2008 Hyundai Elantra 2.0 Timing Belt Replacement
Timing belt replacement is an integral part of car maintenance, and it’s essential to ensure that the vehicle performs at its optimal level. The Hyundai Elantra 2.0 engine is an interference engine, meaning that if the timing belt breaks, the engine valves can interfere with the pistons, causing significant damage. Therefore, replacing the timing belt should not be ignored, and it’s recommended to replace it after every 60,000 miles. This article will guide you on how to replace the timing belt in a 2008 Hyundai Elantra 2.0 model.
Tools and Materials Required
Before embarking on the task, the following tools and materials should be at hand:
- Timing belt kit
- Socket set
- Torque wrench
- Jack and jack stands
- Engine oil drain pan
- New coolant
- New engine oil
- New oil filter
Steps to Replace the Timing Belt
Here are the steps on how to replace the timing belt in a 2008 Hyundai Elantra 2.0:
- Disconnect the negative battery cable of the car.
- Remove the plastic engine cover by unscrewing the bolts or clips holding it in place.
- Drain the engine oil by locating the oil pan bolt underneath the engine and remove it using a socket wrench.
- While the oil is draining, remove the oil filter using an oil filter wrench and replace it with a new one.
- Locate the lower engine mount by the passenger-side tire and remove it using a socket wrench and jack stand.
- Place a jack underneath the engine and raise it slightly to remove the engine mount bracket.
- Remove the power steering belt by loosening the tensioner bolt using a socket wrench.
- Remove the AC belt by loosening the tensioner bolt using a socket wrench.
- Locate the timing belt cover and remove the bolts holding it in place using a socket wrench.
- Locate the timing belt tensioner and release the tension by turning the bolt using a socket wrench.
- Remove the timing belt by sliding it off the pulleys carefully.
- Place the new timing belt on the pulleys and ensure that it’s properly aligned.
- Reset the timing belt tensioner and tighten the bolt using a torque wrench.
- Replace the timing belt cover and tighten the bolts using a torque wrench.
- Reinstall the power steering and AC belts by tightening the tensioner bolts using a socket wrench.
- Replace the engine mount bracket and lower engine mount by tightening the bolts using a socket wrench and jack stand.
- Add new engine oil and replace the oil pan bolt using a socket wrench.
- Add new coolant and replace the radiator cap.
- Reconnect the negative battery cable of the car.
Conclusion
By following these simple steps, you can replace the timing belt in your 2008 Hyundai Elantra 2.0 model. Remember to prioritize the timing belt maintenance and replace it after every 60,000 miles to ensure your car performs optimally. Also, ensure that you have all the necessary tools and materials required for the task.
