2008 Mitsubishi Lancer 2.0 Serpentine Belt Diagram
Introduction
Are you looking for a serpentine belt diagram for your 2008 Mitsubishi Lancer 2.0? You've come to the right place. In this article, we will provide you with a comprehensive guide on how to locate and replace the serpentine belt on your Mitsubishi Lancer. We will also provide you with a diagram to help you better understand the process.
What is a Serpentine Belt?
A serpentine belt, also known as a drive belt, is a long, continuous belt that is used to power accessories such as the power steering pump, alternator, and air conditioning compressor. The serpentine belt is driven by the engine's crankshaft pulley and is responsible for transferring power to these accessories.
When to Replace the Serpentine Belt?
It is recommended to replace the serpentine belt every 60,000 to 100,000 miles. However, if you notice any signs of wear on the belt such as cracks, fraying, or glazing, it is best to replace it as soon as possible to prevent further damage to your engine.
Locating the Serpentine Belt
The serpentine belt on the 2008 Mitsubishi Lancer 2.0 is located on the front of the engine. To locate the belt, open the hood and look for the belt routing diagram, which should be located near the radiator. If the diagram is missing, you can also find the routing diagram in the owner's manual. The diagram will show you the exact path of the belt around the accessories.
Removing the Serpentine Belt
To remove the serpentine belt on your 2008 Mitsubishi Lancer 2.0, you will need a serpentine belt tool or a socket and a breaker bar. Locate the belt tensioner, which is usually located on the passenger side of the engine, and use the serpentine belt tool or socket and breaker bar to rotate the tensioner clockwise. This will release the tension on the belt, allowing you to remove it from the accessories.
Installing the New Serpentine Belt
Before installing the new serpentine belt, make sure that the routing matches the diagram located on the front of the engine or in the owner's manual. Use the serpentine belt tool or socket and breaker bar to rotate the tensioner clockwise and slide the new belt onto the accessories. Make sure the belt is properly seated on all the pulleys and is aligned with the routing diagram.
Conclusion
Replacing the serpentine belt on your 2008 Mitsubishi Lancer 2.0 is a straightforward process that can be completed with basic tools. By following the steps outlined in this article and using the diagram provided, you can replace the serpentine belt on your own and save money on labor costs. Remember to replace the belt every 60,000 to 100,000 miles, or if you notice any signs of wear.
