Cub Cadet Rzt 50 Inch Deck Belt Diagram
Introduction:
Cub Cadet Rzt 50 is a reliable and powerful tractor required for cutting large grass fields. It is important to maintain your tractor properly to ensure maximum performance. One aspect of this maintenance is regularly checking and replacing the deck belt. The following article will provide step-by-step instructions and images to help you replace or adjust the deck belt in your Cub Cadet Rzt 50.
Step 1: Turn Off The Tractor And Remove Blades:
The first step in checking or replacing the deck belt is to turn off the tractor and remove the blades. It is important to wear gloves to protect your hands during this process. Locate the blade-driveshaft by rotating the mower deck manually. This will reveal the idler pulley, which is attached to the deck belt.
Step 2: Remove The Deck Belt:
Locate the idler pulley, which is positioned behind the main pulley. Then, you need to remove the deck belt from the pulley. Once the belt is off, inspect it for any signs of damage. If there is damage, replace the belt.
Step 3: Install The New Belt:
If you need to install a new belt, refer to the instruction manual for the correct type of belt and installation process. Begin by sliding the new belt onto the driveshaft, and then adjust the idler pulley until there is tension on the belt. Rotate the mower deck to confirm that the belt has been installed correctly.
Step 4: Check Belt Tension:
Once you’ve installed the new belt or adjusted the old one, you need to check the belt tension. A loose belt can cause the pulleys to slip, while a belt that is too tight can cause the bearings to overheat. You can check the tension with a belt-tension gauge, available at most automotive stores. A properly-installed belt should have a tension of 500-600 pounds per square inch (psi).
Step 5: Reinstall Blades:
After confirming that the belt is properly installed and tensioned, it is time to reinstall the blades. Make sure they are secured in place and that the bolts are tightened to the correct torque specification.
Step 6: Test The Tractor:
The final step is to start the tractor and test the new belt. Engage the PTO (Power Take Off) and drive the tractor around the yard, observing the performance of the belt. If it’s slipping or making abnormal noises, you may need to adjust the belt further or replace it again.
Conclusion:
Replacing or adjusting the deck belt in your Cub Cadet Rzt 50 is a straightforward process that requires a few basic tools and some patience. By following the steps outlined in this article, you can ensure that your tractor is always in top working condition, ready to tackle even the toughest mowing jobs.
