Hoover Self Propelled Wind Tunnel Vacuum Belt Replacement
If you own a Hoover self propelled wind tunnel vacuum, you know how powerful and efficient it is in cleaning your floors. However, over time, you may need to replace the belt that drives the brushes. In this article, we will guide you through the steps of Hoover self propelled wind tunnel vacuum belt replacement.
When to replace your Hoover self propelled wind tunnel vacuum belt?
The belt in your Hoover self propelled wind tunnel vacuum is responsible for driving the brushes that clean your floors. Over time, the belt may stretch or break, which will result in reduced cleaning performance. It is recommended to check the belt periodically and replace it every six months to ensure optimal cleaning performance.
Tools required for Hoover self propelled wind tunnel vacuum belt replacement
Before starting to replace the belt, you will need a few tools:
- Hoover Wind Tunnel Vacuum Belt
- Phillips head screwdriver
- Flathead screwdriver
Steps for Hoover self propelled wind tunnel vacuum belt replacement
Follow these steps for a successful belt replacement:
- Unplug the vacuum: Safety first. Unplug the vacuum cleaner from the power outlet to avoid any accidents.
- Lower the handle: Flip the handle of the vacuum all the way back until it touches the floor.
- Remove the bottom plate: Unscrew the six screws on the bottom of the vacuum with a Phillips head screwdriver. Once the screws are removed, lift off the bottom plate to expose the belt and brush roll.
- Remove the brush roll: Carefully remove the brush roll by pulling each end out of its slot. Be sure to take note of the orientation of the brush roll, so you can replace it correctly later.
- Remove the old belt: Locate the old belt, which should be loose after removing the brush roll. Gently lift the belt off the motor shaft and brush roll, and then remove it completely.
- Install the new belt: Place the new belt around the motor shaft first, and then around the brush roll. Make sure the belt is seated correctly and aligned with the brush roll.
- Replace the brush roll: Put the brush roll back in place, making sure it is oriented correctly. Make sure the brush roll is firmly in place by attempting to spin it by hand. If it does not move, you know it is in place.
- Replace the bottom plate: Carefully align the bottom plate with the vacuum and screw in the six screws with a Phillips head screwdriver.
- Test the vacuum: Plug the vacuum back in and turn it on. Make sure everything is working correctly by vacuuming a small area before using the vacuum as normal.
Final thoughts
Replacing the belt in your Hoover self propelled wind tunnel vacuum is a relatively easy task if you have the right tools and follow the steps carefully. By replacing the belt every six months or so, you can ensure that your vacuum cleaner will continue to perform at its best, keeping your floors clean and in great condition.