2011 Jeep Grand Cherokee 5.7 Serpentine Belt Diagram
The Jeep Grand Cherokee, a mid-sized SUV, was first introduced in 1999. The 2011 model of the Jeep Grand Cherokee has a 5.7L V8 engine that is capable of producing 360 horsepower. One of the most important components of the engine is the serpentine belt. The serpentine belt is responsible for running multiple components of the engine, such as the alternator, power steering pump, and air conditioning compressor. In this article, we will discuss the serpentine belt diagram for the 2011 Jeep Grand Cherokee 5.7.
Why You Need a Serpentine Belt Diagram
If you are planning to replace the serpentine belt of your 2011 Jeep Grand Cherokee, it is important to have a serpentine belt diagram. The diagram shows the path of the belt around each pulley of the engine. Without the diagram, you will not know the correct path of the belt around the pulleys, which can lead to belt failure or damage to other engine components.
The Serpentine Belt Diagram for the 2011 Jeep Grand Cherokee 5.7
The serpentine belt of the 2011 Jeep Grand Cherokee 5.7 runs around the following pulleys:
- Idler Pulley
- Power Steering Pump Pulley
- Alternator Pulley
- Automatic Tensioner Pulley
- Water Pump Pulley
- A/C Compressor Pulley
When routing the serpentine belt, make sure that the belt is properly aligned around each pulley. The idler pulley should be the first pulley the belt goes around, followed by the power steering pump pulley, alternator pulley, automatic tensioner pulley, water pump pulley, and A/C compressor pulley. The diagram shows the correct path of the belt.
How to Replace the Serpentine Belt on a 2011 Jeep Grand Cherokee 5.7
Replacing the serpentine belt on a 2011 Jeep Grand Cherokee 5.7 is relatively easy. Here are the steps:
- Locate the idler pulley and use a breaker bar to remove tension from the belt.
- Remove the old belt from each pulley.
- Route the new serpentine belt around each pulley according to the diagram.
- Use the breaker bar to apply tension to the belt again to ensure it is tight around each pulley.
It is important to inspect the belt tensioner while replacing the serpentine belt. If the tensioner is worn, it is recommended to replace it at the same time. Also, make sure to inspect each pulley for any signs of wear or damage. If any pulley is worn or damaged, it should be replaced as well.
Conclusion
The 2011 Jeep Grand Cherokee 5.7 serpentine belt diagram shows the correct path of the belt around each pulley of the engine. It is important to follow the diagram when replacing the serpentine belt to avoid belt failure or damage to other engine components. Replacing the serpentine belt on a 2011 Jeep Grand Cherokee 5.7 is relatively easy, but make sure to inspect the belt tensioner and each pulley for any signs of wear or damage before replacing the belt.
