Genie Belt Drive Garage Door Opener Installation Instructions
Installing a Genie belt drive garage door opener is a relatively easy task that can be done by a homeowner with a few basic tools. Before starting the installation process, it is important to familiarize yourself with the various parts and components that come with a Genie belt drive garage door opener. This article will provide you with step-by-step instructions on how to install a Genie belt drive garage door opener.
Tools Needed
Before starting the installation process, you will need the following tools:
- Phillips screwdriver
- Flathead screwdriver
- Drill
- Wrenches
- Level
- Step ladder
Step 1 - Preparing the Opener
The first step in the installation process is to prepare the opener. Begin by unpacking the Genie belt drive garage door opener and check that you have all the parts and components. Ensure that you have the main unit, rail assembly, motor unit, remote control, hardware kit, and safety sensors.
Step 2 - Mounting the Opener to the Ceiling
The next step is to mount the opener to the ceiling. Start by positioning the opener on the ceiling in the desired location. Use a level to ensure that the opener is level. Once the opener is in the correct position, use a pencil to mark the location of the mounting bracket holes. Use a drill to make pilot holes where you marked the location of the mounting bracket holes. Attach the mounting brackets using the screws provided and tighten them securely.
Step 3 - Installing the Rail Assembly
The rail assembly is next to be installed. Starting at the motor unit, connect the rail assembly to the opener with the provided bolts. Once connected, mount the rail assembly to the ceiling using the rail hangers provided. Ensure that the rail assembly is level before tightening the bolts.
Step 4 - Installing the Motor Unit
Once the rail assembly is installed, it is time to install the motor unit. Secure the motor unit to the mounting bracket and connect it to the rail assembly using the provided bolts. Ensure that the motor unit is level before tightening the bolts.
Step 5 - Installing the Belt Drive
Now it's time to install the belt drive. Start by attaching the belt to the rail trolley. Then, loop the belt around the motor drive pulley. Make sure the belt is tight and tensioned before tightening the belt tensioner. Adjust the belt tension by moving the motor assembly up or down.
Step 6 - Installing the Safety Sensors
The last step is to install the safety sensors. The sensors should be mounted on each side of the garage door no more than 6 inches from the floor. The sensors should be facing each other and should be connected to the motor unit using the provided wires. Once installed, test the safety sensors to ensure that they are working correctly.
Conclusion
By following these instructions, you should now have a fully functioning Genie belt drive garage door opener. Remember to follow all safety precautions when operating your garage door, and always consult the owner's manual if you experience any issues or have any questions.