Installing Diono Radian Rxt Rear Facing With Seat Belt
As a parent, the safety of our little ones is our top priority. One of the most important decisions we make as parents is choosing the right car seat for our children. The Diono Radian RXT is a popular choice among parents due to its safety features and versatility. In this article, we will guide you on how to install the Diono Radian RXT rear-facing with the seat belt.
Why Rear-Facing is Important?
Rear-facing car seats are recommended for children until they are 2 years old or have reached the maximum weight and height limit allowed by the car seat manufacturer. Rear-facing seats provide more protection for the child’s head, neck, and spine during a crash. In fact, research shows that children are five times safer in a rear-facing car seat until they have outgrown it.
What is Diono Radian RXT Car Seat?
The Diono Radian RXT is a convertible car seat that can be used in three different modes: rear-facing, forward-facing, and booster mode. The car seat is suitable for children weighing between 5 and 120 pounds, with a maximum height of 57 inches. It is designed with safety features such as a steel frame, energy-absorbing foam, and a five-point harness system.
Steps for Installing Diono Radian RXT Rear Facing with Seat Belt
Before starting the installation process, make sure you have carefully read the car seat manual and the car owner’s manual. Follow these simple steps to install the Diono Radian RXT rear-facing with seat belt:
Step 1: Find the Right Position for the Car Seat
Choose a seating position in the back seat of the car where you can get a tight installation. Make sure the car seat will fit properly in the chosen position and not interfere with the front seat passenger.
Step 2: Adjust the Angle of the Car Seat
The Diono Radian RXT allows for several angle adjustments to achieve the correct recline angle for a rear-facing installation. Use the level lines on the side of the car seat to determine the correct angle based on the age, weight, and height of your child. Use a rolled towel or folded blanket if needed to achieve the correct angle.
Step 3: Install the Car Seat
Place the car seat in the chosen position and route the seat belt through the appropriate belt path. Lock the seat belt and ensure it is tight by applying weight to the car seat and pulling the seat belt. The car seat should not move more than one inch side-to-side or front-to-back. Make sure the car seat is level and flush with the seat of the car.
Step 4: Secure the Child in the Car Seat
Place your child in the car seat and adjust the harness straps to fit snugly. The straps should be at or below your child’s shoulders for a rear-facing installation. Buckle the chest clip and make sure it is at armpit level. Check the tightness of the straps by pinching the webbing at the child’s shoulder. There should be no more than one inch of slack.
Step 5: Check the Installation
After installing the car seat, check the installation by performing a few tests. Check the tightness of the seat belt by trying to move the car seat side-to-side and front-to-back. The car seat should not move more than one inch. Check the angle of the car seat and the position of the child in the car seat. If everything looks good, you are ready to hit the road!
Conclusion
Installing the Diono Radian RXT rear-facing with seat belt may seem daunting at first, but by following these simple steps, you can ensure your child’s safety while traveling. Remember to always read the car seat manual and the car owner’s manual carefully before installing the car seat. With the right installation, you can have peace of mind knowing that your child is safe and secure.
